MDE2706 Electric Dryer

MDE2706 Electric Dryer
Notice: Undefined variable: position6 in /home/domains2/public_html/the-beachboys.com/show.php on line 186

After first Ignition cycle igniter stays on too briefly to open gas valve gas.

Our Matag DG713 worked years with no problems. Now upon first starting (cold start)the igniter stays on long enough to open the gas valve and ignite the gas (about twenty seconds). However once that first flame shuts off, the igniter cycles on for only ten to twelve seconds, not long enough to trigger gas flow. It will continue to cycle this way through the entire drying cycle, never again staying on long enough to start gas flow. When the dryer is turned on after 30 min. cooling down it again ignites - but again once and only once! Help please.

★ ★ ★ ★ ☆ 4.0 stars

MDE2706 Electric Dryer

Product Troubleshooting for MDE2706 Electric Dryer



Notice: Undefined variable: position5 in /home/domains2/public_html/the-beachboys.com/show.php on line 214

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Answers :


Valid Most likely the problem with your dryer is the coils for the gas valve. Remove the access door (on the bottom right side on the front panel) and you can see the gas valve with three coils on top of it. They are coming as a kit with complete instruction. The part number for this kit is AP2669614.You can buy it here http://click.linksynergy.com/fs-bin/click?id=SrmyP8LkIos&offerid=92089.542517043&type=10&subid=

Research, Knowledge and Information :



Notice: Undefined variable: position4 in /home/domains2/public_html/the-beachboys.com/show.php on line 266

Notice: Undefined variable: go_page in /home/domains2/public_html/the-beachboys.com/show.php on line 277

Appliance411 FAQ: Understanding Gas Oven Ignition Systems


... the oven uses the spark type ignition system too. ... by the ignitor or the gas valve being open ... oven valve can repeatedly cycle open and ...
Read More At : www.appliance411.com...

Hot Surface Igniter Operation and Troublehooting - ACHR News


Hot Surface Igniter Operation and Troublehooting. ... Faulty ignition control; Faulty gas valve; ... and therefore to keep the gas valve open, ...
Read More At : www.achrnews.com...

Gas Oven Repair Manual - Chapter 6 | Gas Oven Pilot Flames


... designers use a gas safety valve that does not open until ignition is ... the gas valve first; ... stays closed, so the pilot valve stays open and ...
Read More At : www.appliancerepair.net...

Gas Oven Ignitors - How to Test and Replace Them


Most gas oven systems today are ‘electronic ignition ... warps’ an internal piece of bimetal to open the gas valve. ... Ignitor and valve must be in ...
Read More At : davesrepair.com...

Water Heater Flame Gas Short Cycle Ignitor Problem Sensor ...


Aug 09, 2010 · Water Heater Flame Gas Short Cycle Ignitor Problem Sensor ... Gas Valve/Thermostat ... GAS WATER HEATER PROBLEMS,will not stay light ...

Gas Dryer Troubleshooting | Appliance Aid


Gas flame comes on first few times then quits and igniter keeps ... The coils on the gas valve are very bad for working ... Does the igniter get red and stay ...
Read More At : applianceaid.com...

Diagnose & Repair Gas Igniters on Stoves, Water Heaters ...


Diagnose & Repair Gas Igniters Stoves, Water Heaters, Furnaces, Boilers. GAS IGNITER DEFECTS & REPAIRS - CONTENTS: Gas ignitors or pilotless ignition troubleshooting ...
Read More At : inspectapedia.com...

HVAC Unit 31 Gas Heat Review Questions Flashcards | Quizlet


Start studying HVAC Unit 31 Gas Heat Review Questions. ... Briefly describe a direct burner gas valve ... immediate ignition occurs. The igniter operates off 120V ...
Read More At : quizlet.com...

Having problems with your MDE2706 Electric Dryer ?

Loading ...

Load time: 0.0141 seconds